Hasselblad H2F Uživatelský manuál stáhnout pdf (Strana 32)

Unloading a lm

To remove a lm, remove the lm holder in the same manner

as when loading a lm. Grip the exposed roll of lm rmly and

remove. Ensure the paper backing is wound tightly and that it is

sealed with the band properly (the band may need to be moistened

to activate the adhesive depending on type). Store exposed lms

away from strong light sources and contact with sharp objects. Move

the remaining empty spool to the take-up spool compartment.

Film wind o

When the last frame has been exposed, the lm will automatically

be wound o. However, to wind o a lm sooner, press the lm

wind o button (on the camera). Use a ballpoint pen or similar to

activate it. You must also conrm the message on the grip LCD

before the lm rewinds.

Beeper

e beeper sounds immediately aer the last-but-one frame has been

exposed. is function can be turned o in Custom Options.

1) Fold out the lm holder key and turn it counter-clockwise 90°.

Withdraw the lm holder completely.

2) Place an empty take-up spool in the upper spool holder by

placing one end over the xed stud in the holder and the other

end underneath the sprung spool retaining arm. Rotate the

spool a little if necessary until it clicks into position.

3) Completely remove the retaining paper band from a new roll

of lm and place it in the lower spool holder. See diagram for

correct orientation. Ensure you do not place the lm spool the

wrong way around!

4) Pull 8–10 cm (3–4 in.) of paper backing from the lm roll and

insert the tongue of the backing paper into the slot in the

take-up spool. Turn the spool one complete turn to ensure the

tongue is rmly held in place by the overlying paper backing.

5) Re-insert the lm holder into the main body of the lm maga-

zine ensuring the correct orientation. Press rmly inwards

towards the magazine and pay particular attention to see

that both sides are level with the magazine body before turn-

ing the lm holder key clockwise 90˚ to lock the lm holder in

place and fold the key back into its stored position. You might

nd that increased pressure on the left hand side of the lm

holder will more easily ensure a positive and correct position-

ing in the magazine.

If the camera is active or in standby mode the lm will be

wound automatically by the camera to position the rst frame

by a half-press of the release button (this default function can

be changed in ‘Custom options’ so that the lm is advanced

directly).

Film loading

e lm magazine can be loaded either on or o the camera.

Regularly check the interior of the magazine and remove dust,

particles or any scraps of paper from previous rolls of lm. Load

and unload lm magazines away from direct light sources.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 85 86

Komentáře k této Příručce

Žádné komentáře

Hasselblad H2F Uživatelský manuál Strana 32

Komentáře k této Příručce