Hasselblad H2F Uživatelský manuál stáhnout pdf (Strana 70)

Example of viewnder LCD display

showing Flash set to Rear sync as well

as ´- 1EV´ exposure compensation.

-%.5

FLASH

$2)6%

3 A V E

Red warning triangle and green LED ash

symbol to left of viewnder LCD display.

-%.5

FLASH

 Do not use the integral ﬂash together when another external TTL

ﬂash unit is connected (and used in TTL or A mode)



For full coverage with the integral ﬂash, use 80 mm or longer lenses

(without a lens shade).

Integral ash

The integral ash unit features the following specications:

Guide no. 12

Coverage 56º horizontal, 44º vertical

Maximum light fall-o at side centres - 1EV (50%)

Colour temperature (full ash) 5,000 – 5,600º K

To raise the ash unit into its operative position, slide the ash-unit

catch backwards in the direction of the ash symbol. To return

the ash unit into its closed position, push down on the top of the

unit until it clicks back into place. e ash unit is automatically

activated when it is in the operative position and de-activated

when returned to its stored position.

e green LED ash symbol blinks in the viewnder when the

ash unit is charging and remains stationary when fully charged.

e ash output can also be adjusted for optimum light balance

in ll-ash situations.

To access the controls:

1) Activate the camera and press the FLASH button once.

2) Turn the front control wheel to set the amount of compensa-

tion required:

 • from+3EVthrough-3EV

 • pressClr (AF button) to clear the setting quickly if required.

3) Turn the rear control wheel to set:

 • normalsync(ashtriggeredjustaftertheshutteropens)

 • rearsync(ashtriggeredjustbeforetheshuttercloses)

 • ashmeasure(withnon-TTLashunitsorTTLunitsin

Manual mode)

4) The grip LCD shows the ash mode - Normal or Rear - in the

standard display.

5) When set to Flash Measure, a specic screen requests you to

press the AE-L button in order to make a reading. See below

for details.

Using the integral ash:

1) Slide the ash-unit catch backwards in the direction of the

ash symbol.

2) Press the FLASH button.

3) Choose between Normal or Rear sync by turning the rear

control wheel and the amount of compensation (if required)

by turning the front control wheel.

4) Press Save (Drive ) button. Make an exposure.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 85 86

Komentáře k této Příručce

Žádné komentáře

Hasselblad H2F Uživatelský manuál Strana 70

Komentáře k této Příručce